Things to do before you start:

• Install MilitaryShield before bedtime to allow for drying overnight

• Turn off device and remove battery only if possible

• Use microfiber cloth to clean your screen

• Wash your hands with soap and dry

• Install in clean, dust-free environment

Some Quick Tips:

• Ensure screen protector lays completely flat on the screen. Hold it up against the light to see if you've pushed out all large air bubbles.

• Any bubbles or streaks you see after initial application is normal! They should disappear within 12-72 hours.

• WARNING: Please don't use excessive liquid or excessive heat as it may cause damage to your device, as we are not responsible for the outcome caused by it. As liquid damage could cause corrosion and heat damage can caused the device to malfunction.

Steps:

• Screen Protector for Switch Without Alignment

1. Wash and dry hands to remove oils and dirt.

2. Clean up the device's screen with provided wet and dry wipe.

3. Remove the dust with provided anti-dust stickers.

4. Peel off the protective layer found on the adhesive side.

5. Make sure the side with adhesive face down

6. Hold the handle to make an exact alignment with Switch OLED.

7. With your finger, gently press on the middle of the screen protector to make it adhere to your device.

8. Peel off the handle film slightly

• Screen Protector for Switch With Alignment

1. Wash and dry hands to remove oils and dirt.

2. Remove the left / right handles first .

3. Clean up the device's screen with provided wet and dry wipe.

4. Place the applicator directly on top of your switch screen.

5. Remove the dust with provided anti-dust stickers.

6. Peel off the protective layer found on the adhesive side.

7. Align the top of the screen protector with the applicator.

8. Press down gently until it attaches to the screen surface.

9. Remove the applicator from your switch.